Halcro SSP100 Owner's Manual page 22

The trigger outputs deliver 12 V DC. The
maximum total current (for the three
outputs) is 200 mA.
Only connect
triggers when the power is off or
the unit is disconnected from
mains power, or the trigger
outputs may be damaged.
CAUTION: Halcro recommends
that trigger
maximum length of three meters
and to use shielded cable to
prevent
interference issues.
34 Component video inputs
Accept component video outputs from
video sources.
There are three component video inputs
in the SSP80 and four in the SSP100. All
component video
associated to any of the sources in SRC1
Source Setup
to 10 in the
35 Component video outputs
Connect to the component video inputs
of the video display.
36 HDMI™ outputs
Connect to the HDMI™ input of your
video display unit.
(For display systems with DVI inputs a
HDMI™/DVI adaptor is required.)
or disconnect
cables be a
possible radio
inputs can be
.
37 HDMI™ inputs
There are three high-definition multimedia
interface (HDMI™) inputs in the SSP80
and four in the SSP100.
All HDMI™ inputs can be associated to
any of the sources in the
38 USB control interface
Connects the SSP80/100 to a home
automation system or to a PC for
software updates.
Contact your dealer for details.
39 Analog audio inputs 1 to 10
Inputs for analog outputs of source
devices.
(Connections must always be made to
these inputs even when using only digital
sources [such as DVD players] to ensure
there is always a signal at the record
outputs.)
40 Tape input/output
Connectors for
recorders, including three-head types,
which allow you to monitor the signal
from the tape at the same time it is being
recorded.
41 Record outputs 1 to 2
These outputs carry the signal from the
currently selected analog stereo source
device (except the source connected to
the tape PLAY input or the 7.1 channel
input).
21
Source Setup .
all types of tape
Free Datasheet http://www.datasheet4u.net/