Halcro SSP100 Owner's Manual page 55

54
Mixing Levels
The 'Mix levels' setup defines the source
signal for the aux channel. Aux channel signals
are generated from other audio channels
before delay is added in the DSP (Digital Signal
Processing.
Note: The mix level range is from -100 to 100,
where zero value equals no signal, 100 equals
max. volume and -100 equals max. volume
with phase inverted.
Level range is linear, so for example, a 50
setting means a 6 dB quieter signal than the
100 setting and a 25 setting means a 12 dB
quieter signal than the 100 setting.
AUX CHANNEL SETUP
o
>
Ch 9 config setup
CH 9 CONFIGURATION
-Level
Filter 1 type
-D elay
Filter 1 freq
C 1 h 0 config setu p
Filter 2 type
-Level
Filter 2 freq
-Delay
>
Mix levels
EXIT
CH 9 MIX LEVELS
EXIT
>
Left
Center
Right
Right surround
Back
Left surround
LFE
EXIT
0dB
No
0 ms
-
No
0 dB
-
0ms
0
0
0
0
0
0
0
To set up mix levels:
o From the 'Configuration setup' menu, use
the UP or DOWN keys to highlight 'Mix
levels' and press ENT
o Use the UP or DOWN keys to highlight
the channels you want to select for
mixing.
o Use the LEFT or RIGHT keys to adjust the
source channel levels and phase for
mixing.
o When adjustments are complete, use the
UP or DOWN keys to highlight EXIT and
press ENT to return to the 'Configuration'
menu.
o Use the UP or DOWN keys again to
highlight EXIT and press ENT to return to
the 'Speaker setup' menu.
Free Datasheet http://www.datasheet4u.net/