Viewing The Menus On The Osd - Halcro SSP100 Owner's Manual

Viewing the Menus on the OSD

Main Menu
The SSP80/100
can be viewed on the On Screen Display
(OSD) (4). You can access the menus using
the UTSR1 remote, as explained on page 24,
or using the front panel controls.
To use the front panel controls instead of the
UTSR1 remote, apply the following rules in
place of using the UP (∧) DOWN (∨) LEFT (<)
RIGHT (>) and enter (ENT) keys on the UTSR1
SSP page 3.
•
Main Menu
— to access the SSP80/100
Main Menu
, press the menu button on
the front panel (11)
(This is equivalent to pressing the MENU
key on the UTSR1 SSP page 3.)
•
DOWN (∨)
— scroll through menu options
by repeatedly pressing the menu button
(11)
•
Enter (ENT)
— to access a highlighted
menu setting, turn the volume control (12)
in a clockwise direction
•
RIGHT (>) — to access a highlighted
menu setting, turn the volume control (12)
in a clockwise direction
•
RIGHT (>) — to change a menu setting,
turn the volume control (12) in a
clockwise direction
and setup menus To exit the menu setting, use the menu button
(11) to scroll through the options until EXIT is
highlighted and then turn the volume control
(12) in a clockwise direction to accept.
Note: When using the volume control (12),
one 5-degree turn will 'enter' the selection.
Turning the control further will adjus
settings.
41
t the
Free Datasheet http://www.datasheet4u.net/