Balanced routing
The Balanced routing setup has two options:
Bypass or DSP (Digital Signal Processing).
AUDIO SETUP
Dolby/DTS setup
Preset setup
Tone controls
LFE level
Reverb
Balanced source
>
Balanced routing
EXIT
Bypass
enables the shortest possible signal
routing, where the signal only travels through
the volume controller and directly to the
balanced 7.1 outputs.
DSP processing
is available if DSP is selected.
Note: In 'Bypass' mode, the signal is available
only at the balanced 7.1 outputs and no post-
processing o bass management is available.
r
If using the SSP100, only the Left and Right
channels are routed to the DSP
0dB
2
Off
DSP
.
To change the balanced routing setting:
Audio Setup
o From the
or DOWN keys to highlight 'Balanced
source'.
o Use the LEFT or RIGHT keys to change
the setting.
o Once the setting is correct, use the UP or
DOWN keys to highlight the next setting
to be adjusted or highlight EXIT to save
Main Menu
and return to the
61
menu, use the UP
.
Free Datasheet http://www.datasheet4u.net/