Front Panel - Halcro SSP100 Owner's Manual

18

Front panel

1 IR receiver
The infrared sensor for the SSP80/100
Universal Touch Screen Remote (UTSR1)
control unit.
2 Standby/On button
Switches the SSP80/100 on and into
STANDBY mode (see page 43).
3 Standby LED
LED indicating the system is in STANDBY
mode.
4 Display
High quality display showing SSP80/100
operating condition such as selected
input, operating mode and volume. The
SSP100 display is a high quality 7" (18 cm)
digital TFT screen. The SSP80 display is a
high quality blue VFD screen.
5 Mute button
Mutes the SSP80/100 audio output.
6 DIM button
SSP100 — Pressing the DIM button
switches the TFT screen brightness from
bright to dim. Pressing the DIM button
again increases the brightness of the TFT
screen.
SSP80 — Pressing
switches the VFD screen brightness from
bright to dim. Pressing the DIM button
again increases the brightness of the VFD
screen.
the DIM button
7 Zone button
Activates Zone B control mode to allow
access to the second Zone. (Active in
STANDBY mode
mode.)
8 Source button
Selects the Source control option. Once
pressed, turning
cycles through the available inputs
9 Mode button
Selects the Mode control option. Once
pressed, turning
cycles through the available processing
modes. (See page 27 and the mode
tables on page 92.)
10 THX button
Selects THX processing mode. (Available
modes depend on the input signal type
and speaker configuration.) See page 27.
11 Menu
Selects SETUP mode. The menu is
displayed on the On Screen Display
(OSD). Repeated pressing of the MENU
button allows you to navigate down
through the selected menu page. (A
menu function is selected by rotating the
volume control.) (See page 47.)
but not in SETUP
the volume control
the volume control
Free Datasheet http://www.datasheet4u.net/