Aux Channel Setup - Halcro SSP100 Owner's Manual

52
To set up speaker sizes:
o From the 'Speaker Setup' menu, use the
UP or DOWN keys to highlight 'Size
setup' and press ENT.
o Use the UP or DOWN keys to highlight
the speaker/channel size you want to
adjust.
o Use the LEFT or RIGHT keys to adjust the
size to your desired setting.
o Use the UP or DOWN keys to highlight
EXIT and press ENT to return to the
'Speaker setup' menu.
o If setup is complete for all settings, use
the UP or DOWN keys to highlight EXIT
and press ENT to exit the Speaker setup,
Main Menu
followed by the
Note: The subwoofer crossover range is from
40 Hz to 140 Hz with 10 Hz steps. The
crossover frequency defines the frequency
below, which the low frequency signal does
not travel to small speakers, but is redirec ed
to large speakers and/or a subwoofer.
Subwoofer c ossover filter can be bypassed r
if the subwoofer's own filter is to be used.
Enhanced Bass duplicates the subwoofe
information to both large speakers and
subwoofer. You may desire this in some
cases to get more bass from the system. By
selecting "Off", the low frequencies will play
through the main left and right only This
selection is preferred by THX.
.
t
r
.

Aux channel setup

'Aux channel setup' allows user configuration
of channel 9 and 10 outputs, also known as
'Aux channels'. A
configuration is one of the most common
uses.
AUX CHANNEL SETUP
>
Ch 9 config setup
-Level
-Delay
Ch 10 config setup
-Level
-Delay
EXIT
•
the setup procedure is the same for both
channels
•
if user defined configuration is selected,
mix levels and filter parameters can be
edited
•
'Level' sets the output level of the aux
channel
•
'Delay' allows the output signal to be
delayed for special effects or setting the
correct distance to the listening position
(Max. delay is 80 ms for aux channels,
where 1 millisecond
approx. 1 ft or 0.3 m.)
stereo subwoofer
0 dB
0 ms
0 dB
0 ms
corresponds to
Free Datasheet http://www.datasheet4u.net/