Care And Maintenance; Cleaning - Halcro SSP100 Owner's Manual

Care and Maintenance

The SSP80/100 processors
designed for indoor use only. Under no
circumstances should the surround sound
processor be allowed to get wet. The only
maintenance required is to ensure the unit is
kept clean.

Cleaning

Halcro takes no responsibility for any damage
caused through careless or improper cleaning
techniques.
WARNING: Never use flammable
products
SSP80/100
Please read the following
procedures very carefully
o Before cleaning, turn the power to the
unit off at the mains.
o Use only extremely soft cloths.
o Use a soft dry cloth to remove any dust.
o Add 0.5 fl oz (15 ml) of very mild
household dishwashing detergent to a
1 gallon (4 liter) bucket of tepid water.
o Immerse the soft cloth in the bucket of
water and then wring the cloth out
thoroughly until the cloth is nearly dry.
o Never clean any electrical fittings or
terminals with the damp cloth.
o After using the slightly damp cloth, wipe
over the surfaces with a soft dry cloth,
and then allow the amplifier to air for at
least one hour prior to turning the power
back on.
have been
when cleaning the
If you are unsure about the cleaning of the
SSP80/100 and require more information,
please ask your dealer or contact Halcro at:
service@halcro.com
WARNING:
SSP80/100 processors contain
no user serviceable parts. Please
do not attempt to open the unit
as this will void the war anty and
may expose you to dangerous
vol ages. t
For all service
please con act your dealer.
83
The Halcro
r
requirements
t
Free Datasheet http://www.datasheet4u.net/