Autocalibrate - Level And Distance - Halcro SSP100 Owner's Manual

Autocalibrate — level and distance
There are two steps
Autocalibration; level
autocalibration must be executed first to
provide a more accurate result regarding
subwoofer distance.
Before starting autocalibration, make sure
there is no significant background noise,
which may interfere with the process. Also
have your microphone ready with one AA
battery installed, and connect the cable to the
base of the microphone and tighten the
plastic nut.
There must be no obstruction between the
calibration microphone and the speakers
during the autocalibration process.
Do not stand between the microphone and
any speaker during this process.
SPEAKER SETUP
Level setup
Distance setup
Size setup
Aux channel setup
>
Level Autocalibrate?
Dist. Autocalibrate?
EXIT
involved in the
and distance. Level
To begin autocalibration:
o Connect the microphone cable to the
MIC socket (15) on the SSP80/100 front
panel.
o Place the microphone in the listening
position with the mesh pointing to the
ceiling.
o Switch the microphone ON by moving
the switch towards the dot.
o From the 'Speaker Setup' menu, use the
UP or DOWN keys to highlight 'Level
autocalibrate' and press ENT.
The autocalibrate process will begin, usually
taking a few minutes. Wait until the process is
complete before proceeding.
values will be written to the 'Level setup'.
o Repeat the steps outlined above for
Distance autocalibration.
o Once completed, use the UP or DOWN
keys to highlight EXIT and press ENT to
Main Menu
return to the
o When the autocalibration process is
complete, remove the battery from the
microphone and store in a dry location.
Sometimes, due to interaction with the room,
you may notice irregular results when setting
the level and/or distance
speakers. If this happens, THX recommends
setting them manually.
55
New level
.
of the main
Free Datasheet http://www.datasheet4u.net/