Video Type - Halcro SSP100 Owner's Manual

Continue as follows:
o Use the LEFT or RIGHT keys to adjust the
gain so that the signal never clips and the
peaks are located within a few decibels of
the 0 dB level.
o Use the UP or DOWN keys to change the
scale used.
o To accept the new value, press ENT or
press ESC to
changes.
o Both of these options will return you to
Source Setup
the
Note: Analog Monitor can also be used for
monitoring digital input level however input
gain cannot be changed.

Video type

The video type parameter selects the video
input for the current
Component video and HDMI inputs. The Video
type parameter also
conversion feature that converts Composite
and S-Video to HDMI.
SOURCE SETUP
Source
Title
Digital input
Preset
Analog monitor
>
Video type
Component bypass
EXIT
exit without saving
menu.
,
source from the
includes the Up-
1
SRC 1
HDMI
No change
HDMI1
On
Video type
When adjusting the
the rules below:
•
select 'Off' if Component video and HDMI
is not used with the source being setup
•
assign the Comp 1,2,3,4, HDMI 1,2,3,4
input number to the source if the
component video or HDMI output is
required
•
assign 'Up-conv' (Up-conversion) if the
source being connected does not have a
Component video or HDMI output and
the display is capable of accepting
Component video or HDMI inputs
Up-conversion from Component video to
HDMI is automatic.
For optimum video performance, THX
recommends that video pass through
(bypass) is used.
To adjust the Video type
o Make sure the
Source Setup
highlighted in the
o From the Source Setup
UP or DOWN keys to highlight
o Use the LEFT or RIGHT keys to change
the setting.
o Once the setting is correct, use the UP or
DOWN keys to highlight the next setting
to be adjusted or highlight EXIT to save
Main Menu
and return to the
67
setting, follow
:
correct source is
menu.
menu, use the
Video type
.
.
Free Datasheet http://www.datasheet4u.net/