Scene Leds - Yamaha VP-1 Owner's Manual

Scene LEDs

Scene 1
MODULATION
1 wheel
MODULATION
2 wheel
Foot
controller 1
SCENE CONTROLLER
You can use a foot controller to obtain the same control you get with the SCENE
CONTROLLER knob. Simply connect the foot controller into the SCENE jack on the
VP1's rear panel. The foot controller's highest position corresponds to Scene 1; the
fully depressed position corresponds to Scene 3.
Note also that you can use the SYSTEM mode's "Aftertouch Scene" switch to select
whether or not the scene controller operates on aftertouch data. (
4)
The LED above each SCENE button indicates how "close" you are to that scene. You
can see how this works by watching the LEDs as you move the SCENE
CONTROLLER up and back.
Red: At the scene
Yellow: Close to the scene
Green: Moving away from the scene
Off: Far from the scene
Scene 2
MODULATION
1 wheel
MODULATION
2 wheel
Foot
controller 1
Chapter 3 Learning the Basics
Scenes
Scene 3
MODULATION
1 wheel
MODULATION
2 wheel
Foot
controller 1
REFERENCE: 2-
BASICS
3 - 13