Yamaha VP-1 Owner's Manual page 129

TONE GENERATOR SETTINGS
: TG
SYSTEM F1
Sets the properties of the tone generator.
Master Tune
Controller Init
Controller Hook
AT Scene SW
420.0 ~ 460.0 Hz
off, on
off, on
off, on
Description
• Use this function to set up the tone generator.
• Master Tune: Selects the frequency for keyboard note A3. The VP1 tunes the
entire system relative to this frequency.
• Controller Init: If "on", the VP1 automatically switches controller settings to the
"initial" scene ( REFERENCE: 1-14) when you switch to a new voice. If "off",
the VP1 reads and applies the physical controller settings each time you select a
new voice.
• Controller Hook: Determines how physical controllers become effective after a
scene change. If the setting is "off", each physical controller becomes effective as
soon as you move it. (Controller LEDs are always green.) If the setting is "on", the
physical controller does not become effective until it moves past the internal
controller position established by the scene.
• AT Scene SW: Determines whether aftertouch and touch-EG data are affected by
scene change. If the setting is "off", scene changes will have no affect on internal
controller values for aftertouch and touch EG.
• Press or
EXIT PLAY
• Press F2 ~ F6
to return to PLAY mode.
to change to another SYSTEM-mode function.
SYSTEM Functions
REFERENCE
Chapter 2 SYSTEM Mode
2 - 4