VOICE SETUP: Zoned Aftertouch Split
: VSet
PLAY
F6
Sets the split point for zoned aftertouch.
ZneATSplt
Move cursor to ZneATSplit.
C-2 ~ G8
Description
• Selects the split-point used when zoned aftertouch mode (ZneATMode) is set to
"4:spl_hi" or "5:spl_lo". (See preceding page.)
• If ZneATMode is set to "spl_hi", the VP1 applies aftertouch effect only to notes
from the split-point up.
• If ZneATMode is set to "spl_lo", the VP1 applies aftertouch effect only to notes
from the split-point down.
• The window at the right of the display graphically indicates the range of notes
subject to aftertouch effects. Elements that are "off" are indicated as "------".
Important
• The VP1 will not allow you to make this setting unless you have already set
ZneATMode to "spl_hi" or "spl_lo".
FYI
• You can use the
1
12
buttons to toggle elements on and off during editing.
~
4
buttons to switch among elements, and the
Editing Functions
9
~
REFERENCE
Chapter 1 PLAY Mode
1 - 36