Yamaha VP-1 Owner's Manual page 109

Procedure
1. Check that the Element Switch for the destination element is "on".
If the setting is "off", change it.
2. If the source voice is in a different bank, press the appropriate bank
button ( ~
A
3. Move the cursor to the element that you want to copy. You can move the
cursor using the dial, the cursor buttons (
( ~
1 16
You can use the
the listing (alphabetic
copy operation will produce, proceed to Step 4 below. If you want to skip the
audition stage, jump to Step 5.
4. Press F1 :Audi.
If the source and destination voices have different initial scenes and the
SYSTEM mode's "Scene Copy Mode" is set to "confirm", the LCD displays a
message asking whether you want to swap the element's scene data. If you see
this message, press
unchanged.
The LCD displays the "Now executing!" message while the VP1 sets up for the
audition. When setup is completed, the word "Audi" begins flashing. You can
now play on the keyboard to "audition" the sound that the destination voice
will have after the copy is complete.
While "Audi" is flashing, you can press
between the new sound and the destination voice's original sound. (The word
"Org" on the display flashes to indicate that you are hearing the original
sound.) This allows you to compare the sound of the original voice with the
sound that the voice will have after you complete the copy.
5. Press to proceed.
ENTER
If you prefer to cancel the operation, press
ELEMENT AUDITION screen.
When you press
6. Press INC/YES to execute the copy.
(If you do not want to proceed, press
above.)
FYI
• You can skip the audition step (Step 4) and press
source element. If you do so, the LCD will first display the "Are you sure?" query. If the
source and destination voices have different initial scenes and the SYSTEM mode's "Scene
Copy Mode" is set to "confirm", the LCD will then display a message asking whether you
want to swap the element's scene data.
• When the VP1 copies the element, it also copies the values of all the parameters listed
beneath the dotted line in the VOICE SETUP display (all parameters from PortaMode
down). If MaxNotes is set to 1, then this setting is also copied.
• You can use the 9
).
D
), or the and
INC/YES DEC/NO
:ABC and :123 functions to switch the order of
F6 F7
numerical). If you want to audition the sound that the
to swap data, or
INC/YES
F8
ENTER , the screen displays the "Are you sure?" query.
DEC/NO
ENTER
~ 12 buttons to toggle elements on and off during editing.
Editing Functions
), the program buttons
buttons.
to leave scene data
DEC/NO
:Org to change back and forth
to return to the original
EXIT
or to return to Step 4
EXIT
immediately after selecting the
REFERENCE
Chapter 1 PLAY Mode 1 - 40