Using The Controllers - Yamaha VP-1 Owner's Manual

Using the Controllers

Now let's try using the parameter controllers and scene controller to alter the sound of
"The sound of the Waterbell voice (voice A02)".
Important
• The procedure below assumes that factory-default values are in effect for the Tone
Generator ( REFERENCE: 2-4) and Assignable Controller (
10) settings. If these values have been changed, the controllers may not operate as
described.
Procedure
1. Press bank button
The LED above the button begins flashing.
2. Press program button
The LCD changes to the display illustrated below, indicating that the
selected voice is A02, "WaterBell."
3. Play on the keyboard.
Familiarize yourself with the sound of the voice.
4. Press .
SCENE2
The LED goes off, and the
SCENE1
5. Play on the keyboard again.
The voice now has a noticeably different sound.
6. Press .
SCENE3
The LED goes off, and the
SCENE2
7. Play on the keyboard once again.
The sound of the voice has changed again.
You can record up to three scenes for each voice, and instantaneously switch
among them. Each scene consists of a prerecorded combination of controller
settings. For further information about scenes, refer to the next chapter. (
BASICS: 3-11)
8. Move the SCENE CONTROLLER all the way to the right.
.
A
.
2
LED comes on.
SCENE2
LED comes on.
SCENE3
First Try
REFERENCE: 2-
BASICS
Chapter 2 Trying It Out
2 - 4