Engine Stop Solenoid - Kubota M5640SU Workshop Manual

M5640SU, M5640DT-SU, WSM

[5] ENGINE STOP SOLENOID

Functional Check
1. Remove the engine stop solenoid (2) from the injection pump.
2. Connect the leads as shown in the figure.
• Connect the jumper leads from terminal P through the
switch (4) to the battery positive terminal.
• Connect the jumper leads from terminal H through the
switch (3) to the battery positive terminal.
• Connect the jumper leads from the negative terminal to the
engine stop solenoid body.
3. When switch (4) is turn ON, the plunger is pulled into the
solenoid body and then turn OFF the switch (4), the plunger
comes out.
4. Turn on the switch (3) then turn ON the switch (4), the plunger
is pulled into the solenoid body and it is kept in HOLDING
position after turning OFF the switch (4).
5. If the plunger is not attracted, the engine stop solenoid is faulty.
IMPORTANT
• Never apply the current for pulling coil more than two
seconds when inspecting.
(1) Connector
(2) Engine Stop Solenoid
(3) Switch for Holding Coil
(4) Switch for Pulling Coil
(5) Battery
9-S14
ELECTRICAL SYSTEM
P : Terminal for Pulling Coil
H : Terminal for Holding Coil
9Y1210365ELS0037US0
KiSC issued 07, 2009 A