E3B Engine; Cylinder Number - Kubota M5640SU Workshop Manual

Hide thumbs Also See for M5640SU:
Table of Contents

Advertisement

M5640SU, M5640DT-SU, WSM

[2] E3B ENGINE

[Example : Engine Model Name V2403-M-TE3]
The emission controls previously implemented in various countries to prevent air pollution will be stepped up as
Non-Road Emission Standards continue to change. The timing or applicable date of the specific Non-Road Emission
regulations depends on the engine output classification.
Over the past several years, Kubota has been supplying diesel engines that comply with regulations in the
respective countries affected by Non-Road Emission regulations. For Kubota Engines, E3 will be the designation that
identifies engine models affected by the next emission phase (See the table below).
When servicing or repairing engine, use only replacement parts for that specific E3 engine, designated by the
appropriate E3 Kubota Parts List and perform all maintenance services listed in the appropriate Kubota Operator's
Manual or in the appropriate E3 Kubota Workshop Manual. Use of incorrect replacement parts or replacement parts
from other emission level engines (for example: E2 engines), may result in emission levels out of compliance with the
original E3 design and EPA or other applicable regulations. Please refer to the emission label located on the engine
head cover to identify Output classification and Emission Control Information. E3 engines are identified with "ET" at
the end of the Model designation, on the US EPA label. Please note : E3 is not marked on the engine.

[3] CYLINDER NUMBER

Category (1)
Engine output classification
K
From 19 to less than 37 kW
J
From 37 to less than 75 kW
I
From 75 to less than 130 kW
Category (2)
Engine output classification
Less than 19kW
From 19 to less than 56 kW
ET
From 56 to less than 75 kW
From 75 to less than 130 kW
(1) EU regulation engine output classification category
(2) "E3B" engines are identified with "ET" at the end of the Model designation, on
the US EPA label.
"E3B" designates Tier 3 and some Interim Tier 4 / Tier 4 models, depending on
engine output classification.
The cylinder numbers of V2403-M-TE3 diesel engine are
designated as shown in the figure.
The sequence of cylinder numbers is given as No. 1, No. 2,
No. 3 and No. 4 starting from the gear case side.
G-3
GENERAL
EU regulation
STAGE IIIA
STAGE IIIA
STAGE IIIA
EPA regulation
Tier 4
Interim Tier 4
Tier 3
Tier 3
9Y1210365GEG0076US0
9Y1210365GEG0077US0
KiSC issued 07, 2009 A

Advertisement

Table of Contents
loading

This manual is also suitable for:

M5640dt-su

Table of Contents