Kubota M5640SU Workshop Manual page 113

M5640SU, M5640DT-SU, WSM
Fuel Tank
1. Remove the fuel pipe (4) from fuel filter and then drain the fuel.
2. Disconnect the fuel return pipes (3).
3. Remove the fuel tank band (2).
4. Remove the fuel tank (1) and fuel tank support (5).
(1) Fuel Tank
(2) Fuel Tank Band
(3) Fuel Return Pipe
Separating Engine from Front Axle Frame
1. Remove the original engine hooks.
2. Install the engine hooks. (Refer to the "8. SPECIAL TOOLS" at
"G. GENERAL" section.)
3. Hoist the engine by the chain at the engine hook.
4. Remove the front axle frame mounting screw.
5. Separate the engine from the front axle frame (1).
(When reassembling)
• Lift the front of the axle frame by the gap in the bolt hole, and
tighten the front axle mounting screws.
Front axle frame mounting
screw (M10)
Tightening torque
Front axle frame mounting
screw (M12)
(1) Front Axle Frame
1-S25
ENGINE
(4) Fuel Pipe
(5) Fuel Tank Support
9Y1210365ENS0027US0
60.8 to 70.5 N·m
6.2 to 7.2 kgf·m
44.9 to 52.1 lbf·ft
44.9 to 52.1 lbf·ft
10.5 to 12.5 kgf·m
76.0 to 86.8 lbf·ft
9Y1210365ENS0028US0
KiSC issued 07, 2009 A