Engine Stop Solenoid - Kubota L3200 Workshop Manual

L3200, WSM

(6) Engine Stop Solenoid

Glow Plug Continuity
1. Disconnect the lead from the glow plugs.
2. Measure the resistance between the glow plug terminal and the
chassis.
3. If 0 ohm is indicated, the screw at the tip of the glow plug and the
housing are short-circuited.
4. If the factory specification is not indicated, the glow plug is faulty.
Glow plug resistance Factory spec.
Connector Voltage
1. Disconnect the 2P connector from engine stop solenoid.
2. Turn the main switch key to the "ON" position.
3. Measure the voltage between the terminal 1, terminal 2 and
body.
4. If the voltage differs from the battery voltage, the wiring harness
of main switch is faulty.
Terminal 1 -Body
Voltage
Terminal 2 -Body
(1) Terminal 1
Stop Solenoid Coil
1. Disconnect the 2P connector from engine stop solenoid.
2. Measure the resistance between the terminal 1, terminal 2 and
body.
3. If resistance differs from factory specification, the coil is faulty.
Terminal 1 -Body
Resistance
Terminal 2 -Body
(1) Terminal 1 (Pulling Coil)
9-S12
ELECTRICAL SYSTEM
Approx. 0.9 Ω
W10559180
Approx. battery voltage
(2) Terminal 2
W10561170
Approx. 0.375 Ω
Approx. 15.6 Ω
(2) Terminal 2 (Holding Coil)
W1071223
KiSC issued 12, 2006 A