Kubota M5640SU Workshop Manual page 222

M5640SU, M5640DT-SU, WSM
ROPS Upper and Rear Wheels
1. Place the disassembling stand under the clutch housing case
and transmission case.
2. Install the front axle rocking resister (refer to the "8. SPECIAL
TOOLS" at "G. GENERAL" section).
3. Remove the lift rod (5), lower link (6) and stabilizer (4).
4. Remove the ROPS upper frame (1).
5. Remove the rear wheels (3).
(When reassembling)
• After tighten the ROPS mounting bolt (2) and nut, install the
cotter pin as shown in the figure.
• Tighten the ROPS upper frame mounting bolts and nuts so that
the ROPS upper frame (1) does not fall down when the ROPS
upper frame (1) positioned at horizontal.
Tightening torque Rear wheel mounting nut
(1) ROPS Upper Frame
(2) ROPS Mounting Bolt
(3) Rear Wheel
Fender and ROPS Under Frame
1. Remove the center frame screws (1).
2. Disconnect the connector for rear combination lamp.
3. Remove the fender L.H. (2).
4. Remove the PTO lever cover from the fender R.H. (5) and
disconnect the connectors for PTO switch.
5. Remove the fender R.H. (5).
6. Remove the ROPS under frames (3) and bracket (4).
(When reassembling)
ROPS under frame
Tightening torque mounting bolt and nut
(M16, 9T)
(1) Center Frame Screw
(2) Fender L.H.
(3) ROPS Under Frame
4-S5
REAR AXLE
260 to 304 N·m
26.5 to 31.0 kgf·m
192 to 224 lbf·ft
(4) Stabilizer
(5) Lift Rod
(6) Lower Link
9Y1210365CLS0032US0
260 to 304 N·m
26.5 to 31.0 kgf·m
192 to 224 lbf·ft
(4) Bracket
(5) Fender R.H.
9Y1210365RAS0004US0
KiSC issued 07, 2009 A