Kubota M5640SU Workshop Manual page 110

M5640SU, M5640DT-SU, WSM
Wirings
1. Disconnect the connector (1) from coolant temperature sensor.
2. Disconnect the 2P connector (3) and wiring (2) for the
alternator.
3. Disconnect the B terminal (6) and 1P connector (7) for the
starter motor.
4. Remove the clutch rod (5).
5. Disconnect the 1P connector for the engine oil pressure switch.
(When reassembling)
Starter B terminal mounting
Tightening torque
nut
(1) Connector (Coolant Temperature
Sensor)
(2) Wiring (Alternator)
(3) 2P Connector (Alternator)
Propeller Shaft
1. Slide the propeller shaft cover (4) and (5) after removing the
screws.
2. Tap out the spring pin (1), (7) and then slide the coupling (2), (6)
to the front and rear.
(When reassembling)
• Apply grease to the splines of the propeller shaft (3).
(1) Spring Pin
(2) Coupling
(3) Propeller Shaft
(4) Propeller Shaft Cover
1-S22
ENGINE
7.8 to 9.8 N·m
0.8 to 1.0 kgf·m
5.8 to 7.2 lbf·ft
(4) 1P Connector (Engine Oil Pressure
Switch)
(5) Clutch Rod
(6) B Terminal (Starter Motor)
(7) 1P Connector (Starter Motor)
9Y1210365ENS0021US0
(5) Propeller Shaft Cover
(6) Coupling
(7) Spring Pin
9Y1210365ENS0022US0
KiSC issued 07, 2009 A