Kubota M5640SU Workshop Manual page 60

M5640SU, M5640DT-SU, WSM
Injection Pump Pressure Tester
Application
• Use to check fuel tightness of injection pumps.
NOTE
• This special tool is not provided, so make it referring to the
figure.
Pressure gauge full scale : More than 29.4 MPa (300 kgf/cm
A
psi)
B Copper gasket
C Flange (Material : Steel)
D Hex. nut 27 mm (1.06 in.) across the plat
E Injection pipe
F PF 1/2
G 5 mm (0.20 in.)
H 17 mm dia. (0.67 in. dia.)
I 8 mm dia. (0.31 in. dia.)
J 1.0 mm (0.039 in.)
K 17 mm dia. (0.67 in. dia.)
L 6.10 to 6.20 mm dia. (0.2402 to 0.2441 in. dia.)
M 8 mm (0.31 in.)
N 4 mm (0.16 in.)
O 11.97 to 11.99 mm dia. (0.4713 to 0.4721 in. dia.)
P PF 1/2
Q 23 mm (0.91 in.)
R 17 mm (0.67 in.)
S 4 mm (0.16 in.)
T 12.00 to 12.02 mm dia. (0.4724 to 0.4732 in. dia.)
U 100 mm (3.94 in.)
V M12 × P1.5
a Adhesive application
b Fillet welding on the enter circumference
G-44
GENERAL
2
, 4267
9Y1210365GEG0059US0
KiSC issued 07, 2009 A