Handling Of Circuit Tester - Kubota M5640SU Workshop Manual

M5640SU, M5640DT-SU, WSM

[5] HANDLING OF CIRCUIT TESTER

• Use sandpaper to remove rust from terminals.
• Repair deformed terminal. Make certain there is no terminal
being exposed or displaced.
(1) Exposed Terminal
(2) Deformed Terminal
• Make certain that there is no female connector being too open.
(A) Correct
• Make certain plastic cover is large enough to cover whole
connector.
(1) Cover
• Use tester correctly following manual provided with tester.
• Check for polarity and range.
G-8
GENERAL
(3) Sandpaper
(4) Rust
WSM000001GEG0075US1
(B) Incorrect
WSM000001GEG0076US1
(A) Correct
(B) Incorrect
WSM000001GEG0077US1
WSM000001GEG0078US1
KiSC issued 07, 2009 A