Tires; Tire Pressure - Kubota M5640SU Workshop Manual

M5640SU, M5640DT-SU, WSM

9. TIRES

[1] TIRE PRESSURE

Though the tire pressure is factory-set to the prescribed level, it
naturally drops slowly in the course of time. Thus, check it everyday
and inflate as necessary. To inflate the wheel tires, use an air
compressor or hand pump.
• Recommended inflation pressure
Maintain the pressure shown below.
NOTE
• Maintain the maximum pressure in front tires, if using a
front loader or when equipped with a full load of front
weights.
Tire sizes
8.3-24, 6PR
9.5-22, 6PR
Front
4WD
29 x 12.5-15NHS
12.5 / 80-18, R4
6.50-16, 6PR
7.50-16, 6PR
Front
2WD
9.5L-15, 6PR
29 x 12.5-15NHS
14.9-28
16.9-28
Rear
21.5L-16.1, R3
16.9-24, R4
WARNING
• Do not attempt to mount a tire on a rim. This should be
done by a qualified person with the proper equipment.
• Always maintain the correct tire pressure.
Do not inflate tires above the recommended pressure
shown in the operator's manual.
IMPORTANT
• Do not use tires other than those approved by KUBOTA.
(A) Insufficient
(B) Standard
(C) Excessive
G-58
GENERAL
Inflation Pressure
2
200 kPa (2.0 kgf/cm , 29 psi)
2
200 kPa (2.0 kgf/cm , 29 psi)
2
138 kPa (1.4 kgf/cm , 20 psi)
2
317 kPa (3.2 kgf/cm , 46 psi)
2
317 kPa (3.2 kgf/cm , 46 psi)
2
276 kPa (2.8 kgf/cm , 40 psi)
2
220 kPa (2.2 kgf/cm , 32 psi)
2
138 kPa (1.4 kgf/cm , 20 psi)
2
138 kPa (1.4 kgf/cm , 20 psi)
2
124 kPa (1.3 kgf/cm , 18 psi)
2
83 kPa (0.84 kgf/cm , 12 psi)
2
193 kPa (2.0 kgf/cm , 28 psi)
(1) Ground
9Y1210365GEG0046US0
KiSC issued 07, 2009 A