Kubota M5640SU Workshop Manual page 173

M5640SU, M5640DT-SU, WSM
Clutch Case
1. Remove the internal snap ring (1).
2. Remove the external snap ring (2).
3. Remove the clutch case (7) and brake disc (5).
(When reassembling)
• Direct the contact part of the brake disc (5) to the brake plate (6).
• Apply small amount of the grease to the seal rings (8).
(1) Internal Snap Ring
(2) External snap Ring
(3) Clutch Holder
(4) Collar
Brake Plate
1. Remove the brake plate mounting screws (3) and then take out
the brake plate (4) and the springs (2).
(When reassembling)
• Apply liquid lock (Three Bond 1372 or equivalent) to the brake
plate mounting screws (3).
Brake plate mounting
Tightening torque
screw
(1) Clutch Case
(2) Spring
Piston
1. Press the washer (6) using the hydraulic clutch spring
compressor. (Refer to "8. SPECIAL TOOLS" at "G. GENERAL"
section.)
2. Remove the external circlip (7).
3. Remove the piston (4).
(When reassembling)
• Apply enough transmission fluid to seal ring (3) and (7).
(1) Clutch Case
(2) Jig
(3) Seal Ring
(4) Piston
(5) Spring
2-S17
CLUTCH
(5) Brake Disc
(6) Brake Plate
(7) Clutch Case
(8) Seal Ring
9Y1210365CLS0019US0
9.81 to 11.2 N·m
1.00 to 1.15 kgf·m
7.24 to 8.31 lbf·ft
(3) Brake Plate Mounting Screw
(4) Brake Plate
9Y1210365CLS0020US0
(6) Washer
(7) External Snap Ring
(8) Seal Ring
A : 41 mm (1.6 in.)
9Y1210365CLS0036US0
KiSC issued 07, 2009 A