Disassembling The Linkage - Kubota M5640SU Workshop Manual

M5640SU, M5640DT-SU, WSM

(3) Disassembling the Linkage

Position Linkage
1. Remove the position feedback rod (4).
2. Remove the feedback lever (5) after removed the roll pin (6).
3. Remove the set plate (3) mounting screw.
4. Slide the feedback shaft (2) and remove the spool drive lever
(1).
5. Remove the position lever holder mounting nut.
6. Remove the external snap ring (10) and roll pin (9).
7. Remove the clip (11) and position shaft (12) with position control
lever.
(When reassembling)
• Set the O-rings (7) from out side of the case.
• Adjust the position control lever operating force after
assembled.
(1) Spool Drive Lever
(2) Feedback Shaft
(3) Set Plate
(4) Position Feedback Rod
(5) Feedback Lever
(6) Roll Pin
8-S13
HYDRAULIC SYSTEM
(7) O-ring
(8) Position Lever Holder
(9) Roll Pin
(10) External Snap Ring
(11) Clip
(12) Position Shaft
9Y1210365HYS0011US0
KiSC issued 07, 2009 A