Kubota M5640SU Workshop Manual page 169

M5640SU, M5640DT-SU, WSM
Seat, Fender and ROPS Under Frame
1. Remove the seat (3).
2. Remove the position control lever grips (2).
3. Remove the auxiliary speed change lever grip (5), DT shift lever
grip (4) and 3-point hitch lowering speed control grip (6).
4. Remove the auxiliary control valve lever assembly (1).
5. Remove the center frame screws (7).
6. Disconnect the connector for rear combination lamp.
7. Remove the fender L.H. (8).
8. Remove the PTO lever cover from the fender R.H. (10) and
disconnect the connectors for PTO switch.
9. Remove the fender R.H. (11).
10. Remove the ROPS under frames (9) and bracket (10).
(When reassembling)
ROPS under frame
Tightening torque mounting bolt and nut
(M16, 9T)
(1) Auxiliary Control Lever
(2) Position Control Lever Grip
(3) Seat
(4) DT Shift Lever Grip
(5) Auxiliary Speed Change Lever Grip
(6) 3-Point Hitch Lowering Speed
Control Grip
Seat Stay, Center Frame and Step
1. Disconnect the wire harness (4) from seat switch.
2. Remove the seat stay (2).
3. Remove the center frame (3).
4. Remove the cover (1) and step (5) for both side.
(1) Cover
(2) Seat Stay
(3) Center Frame
Hydraulic Pipes
1. Remove the suction pipe (2).
2. Remove the delivery pipe (1) for the three point hydraulic
system.
3. Remove the brake rod (3).
(1) Delivery Pipe
(2) Suction Pipe
2-S13
CLUTCH
260 to 304 N·m
26.5 to 31.0 kgf·m
192 to 224 lbf·ft
(7) Center Frame Screw
(8) Fender L.H.
(9) ROPS Under Frame
(10) Bracket
(11) Fender R.H.
9Y1210365CLS0033US0
(4) Wire Harness
(5) Step
9Y1210365CLS0034US0
(3) Brake Rod
9Y1210365CLS0016US0
KiSC issued 07, 2009 A