Table of Contents
Advertisement
DAAB AUTOMATIC CONTROL UNIT EP104
• Signal reference
Safety edge 1, closing movement (S.E1)
Safety edge 2, closing movement (S.E2)
Safety edge, opening movement (S.E3)
Shared limit switch, motor 1
Limit switch open motor 1
Limit switch closed motor 1
Shared limit switch, motor 2
Limit switch open motor 2
Limit switch closed motor 2
Shared programmable input 1 & 2
Programmable input 1
Programmable input 2
Shared programmable input 3 & 4
Programmable input 3
Programmable input 4
Shared programmable input 5 & 6
Programmable input 5
Programmable input 6
Input for photocell and external loop detector
Communication (interlock)
24 VDC (max. 300 mA)
Connection points
12 VDC (max. 50 mA)
Output for self test
• Low current
The safety circuit, safety edge or limit switch must not be connected to, or used for, any other function. If signals from
!
the EP104 are needed, a separate output card must be used.
The connection instructions are the same for all types of application, but not all signals may be needed.
If stop signals are unused, the associated input signals must be jumpered on the terminal block, see "Signal reference".
Note that the 24 V for the stop circuit must not be combined with other 24 V circuits.
!
Bruksanvisning utgåva 1 för Programversion 4.06
Stop input 1
Stop input 2
Stop input 3
RS 485
+
-
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
+
29
UT
30
-
31
32
33
34
35
36
37
38
24VDC
24VDC
300mA
17
Advertisement
Table of Contents
