Vehicle Detector, D Channels; Vehicle Loop 1 - DAAB EP104 Instruction Manual

• Vehicle detector, d channels

Vehicle loop 1

No. Name
d100 Loop 1 used
0 Input disabled
1 Input enabled
d101 Loop reading x1
d102 Loop reading x1000
d103 Activation by passing vehicle
d110 Detection limit for a vehicle in the loop
d111 Difference between on and off in the loop
d120 Loop presence reset
d121 Fast loop presence reset
d131 Compensation for activation from door half motor
1 on the loop in the closed position
d132 Compensation for activation from door half motor
2 on the loop in the closed position
d140 Safety function in closing movement
0 Disabled
1 Reverse
2 Stop with automatic restart of automatic closing
3 Stop without automatic restart of automatic closing, wait for new control signal
4 Safety only in the open position, when the limit switch is interrupted. Used when the gate passes over
the loop in the closing movement.
d141 Safety during run-on time or disengagement angle
in closing movement
0 Disabled
1 Enabled and subordinated to d140
d142 Safety function in opening movement
0 Disabled
1 Reverse to fully closed
2 Stop with automatic restart of automatic closing
3 Stop without automatic restart of automatic closing, wait for new control signal
4 Safety only in the closed position, when the limit switch is interrupted. Used when the gate passes over
the loop in the opening movement.
d151 Loop-based closing
0 Disabled
1 Active
d154 Type of closing
1 Close immediately when loop is clear
2 Continue to fully open, then close
•
48
DAAB AUTOMATIC CONTROL UNIT EP104
Range Factory Setting Ref.
0 – 1 0
000-999
00-99
000-999
05-99 15
00-50 03
000 and 005-240 120
minutes
00-99 seconds 00
00-50 03
00-50 03
0 - 4 1
0 – 1 1
0 - 4 0
0 - 1 0
1 - 2 2
Bruksanvisning utgåva 1 för Programversion 4.06
page