DAAB EP104 Instruction Manual page 51

DAAB AUTOMATIC CONTROL UNIT EP104
No. Name
d260 Control function
0 Disabled
1 Open
d261 Type of control signal when activated
1 Pulse
2 Signal when loop is activated
d262 Half operation
1 Motor 1
2 Motor 2
3 Motors 1 and 2
d263 Limited opening
0 Disabled
1 Opening for the time set in channels C412 and C414 or degrees in L116 and L126
d270 Allows the opening function, via LOOP2, using a
programmable input.
0 Disabled, normal opening/closing function. (Programmable input has no function for LOOP2)
1 Opening/closing possible only if there is a signal at programmable input 1
2 Opening/closing possible only if there is a signal at programmable input 2
3 Opening/closing possible only if there is a signal at programmable input 3
4 Opening/closing possible only if there is a signal at programmable input 4
5 Opening/closing possible only if there is a signal at programmable input 5
6 Opening/closing possible only if there is a signal at programmable input 6
d275 Opening via loop after activation for the set time,
the loop will not open the gate before it has been
activated for the set time.
d290 Interlock opening
0 Disabled
1 Sends a normal open signal to the remote door
Bruksanvisning utgåva 1 för Programversion 4.06
Range Factory Setting Ref.
0 - 1 0
1 - 2 1
1 - 3 3
0 - 1 0
0 - 6 0
0.0-9.9 seconds 0.0
0 - 1 0
page
35
51