Programmable Output 2 - DAAB EP104 Instruction Manual

DAAB AUTOMATIC CONTROL UNIT EP104

Programmable output 2

No. Name
o200 Function of output 2
0 Disabled
1 Position indication/Movement/Warning. Signal as configured in o210 – o222
2 Presence sensor/Direction sensing. Signal as configured in o291
3 Lock
4 Alarm output Signal as configured in o230 – o239
o210 Open position
0 Disabled
1 Constant signal
o211 Mid position
0 Disabled
1 Constant signal
o212 Closed position
0 Disabled
1 Constant signal
o213 Movement
0 Disabled
1 Constant signal in the opening movement
2 Constant signal in the closing movement
3 Constant signal in the opening and closing movement
4 No signal during movement, used in combination with o210, o211 and o212.
o214 Delayed switch-off Switch off after the specified
time For example to switch off lighting a specified
time after closing
o220 Warning time before start
o221 Warning function in combination with o220
1 Constant signal before park and automatic closing
2 Constant signal before close signal, park and automatic closing
3 Constant signal before all signals
o222 Function during warning time
1 Output signal deactivated during warning
2 Output signal as configured in o210-o213
o230* Alarm if there is an error as configured in
o231-o239. The alarm is activated for at least the
time set in this channel.
o231* Alarm for faulty safety edge. Time as in o230.
0 Constant signal
1 Active
o232* Alarm for error message in display
0 Constant signal
1 Active
* = Only when o200 is set to 4.
Bruksanvisning utgåva 1 för Programversion 4.06
Range Factory Setting Ref.
0 - 4 1
0 - 1 0
0 - 1 0
0 - 1 1
0 - 4 4
0.00-9.59 minutes 0.00
0.00-9.59 minutes 0.00
1 - 3 1
1 - 2 1
0.00-9.59 minutes 0.00
0 - 1 0
0 - 1 0
page
57