Power Extension Cable; Power Extension Cable (For Stp Control Unit) - Edwards STP-XF1303 Series Instruction Manual

3.6.6

Power extension cable

3
input of the "X1 AC IN" connector. Even when the STC-U breaker is "OFF", the output
isolate (Lockout/Tagout) the electrical energy source, water and gas, and other energy
sources on the vacuum equipment. Failure to do so may result in an electric shock or
The "X2 AC OUT" connector of the STC-U is a connector dedicated for supplying power to the STP
Connect the plug (pin) side of the power extension cable to the "X2 AC OUT" of the STC-U and
connect the receptacle (socket) side to "X2 AC POWER" of STP control unit.
To "X2 AC POWER" of STP control unit
MT-92E-A01-C
Page 24
The output of the "X2 AC OUT" connector of the STC-U is directly connected to the
of "X2 AC OUT" will not be shut off. When connecting/disconnecting cables, always
control unit. DO NOT connect to other equipment.
1
1. 4 pin (socket)
Figure 22 - Power extension cable (for STP control unit)
STC-U eTMS unit
WARNING
damage to equipment.
CAUTION
2. 3 pin (pin)
To "X2 AC OUT" of STC-U
2