K7Tm Basic Settings - Omron K6CM Usage Manual

2 Basic Settings
2-4

K7TM Basic Settings

The Initial Settings and Reference Resistance Value Registration in the Basic Settings are described
below. Refer to 1-3 Communication Settings (Home Screen (2)) for information on Communication
Settings.
K7TM does not have Trigger Settings.
K7TM Initial Settings
This is the Initial Settings Screen in the Basic
Settings.
Setting parameters are as follows:
Heater Condition Monitoring Device
K7TM-A2
*1. If you select Temperature for the Stabilization Discrimination Method parameter, the following parameters will
be displayed.
Baud Rate 1, Parity1, Send Wait Time 1, Temperature Set Point, Temperature Data Write Cycle
For details on setting parameters, hover your mouse over the "i" mark on the screen to display hints
and instructions. Set the parameters according to those instructions.
32
Initial Settings
Setting Parameter
Maximum Number of Channels, CT Input Range, Voltage Input
Range, Measurement Value Calculation Cycle, Stabilization Dis-
crimination Method*1, Alarm Polarity, Alarm Output Level, Use
Running Time
Condition Monitoring Configuration Tool Usage Guide (N240)