Omron K6CM Usage Manual page 20

1 Common Settings
 K6CM and K6PM
2
Enter the IP address of the condition
monitoring device in the Communi-
cation Test Field and click the Exe-
cute Button.
The results of the communication
test is displayed as a message.
If the communication test is success-
ful, proceed with the settings.
If the communication test fails, follow
the instructions in the message and
retry the communication test.
When the condition monitoring
device and this Tool are successfully
connected, the IP address, Subnet
Mask, and Default Gateway will be
automatically displayed in each
Field.
If you want to change the IP
address, change the settings on the
screen and click the Write Button.
 K7GE, K7TM and K7DD
2
Enter the IP address of the RS-485
to Ethernet communications con-
verter in the IP Address Field.
3
From the Slave Address pull-down
Menu, select the communication
unit number that is set with the
rotary switches on the model K7**.
4
Click the Execute Button in Com-
munication Test Field.
The results of the Communication
Test is displayed as a message.
If the Communication Test is suc-
cessful, proceed with the settings.
If the communication test fails, fol-
low the instructions in the message
and retry the communication test.
5
Click the Next Button if Succeeded
is displayed in the Communication
Test Field.
Move to Home Screen (3).
Optional Command
A pop-up for Modbus optional commands is displayed by clicking the Optional Command Button,
enabling you to send any Modbus command of your choice. For information on the send
commands, refer to the manuals of the condition monitoring devices.
You can set the IP Address, Subnet Mask, and Default Gateway for K6CM and K6PM. Execute the
Communication Test again after setting them.
18
K6CM/K6PM Communication Settings Dialog Box
K7GE/K7TM/K7DD Communication Settings Dialog Box
Condition Monitoring Configuration Tool Usage Guide (N240)