Omron K6CM Usage Manual page 29

K6CM Trigger Settings
The Trigger Settings are used to specify the measurement timing conducted by the condition
monitoring device.
If noise is induced when the equipment starts up or when operation is unstable, set the measurement
timing while taking into consideration the time required for noise removal over a specified period. Refer
to Section 3 Measuring and monitoring System of the K6CM User's Manual (N224) for details.
This is the Trigger Settings Screen in the
Basic Settings. The settings for the three
K6CM models are as follows:
Motor Condition Monitoring Device
K6CM-CI2 Comprehensive current diagnosis
type
K6CM-VB Vibration & temperature type
K6CM-IS Insulation resistance type
For details on setting parameters, hover your mouse over the "i" mark on the screen to display hints
and instructions. Set the parameters according to those instructions.
Condition Monitoring Configuration Tool Usage Guide (N240)
Trigger Settings
Setting Parameter
Trigger Mode, Current Moving Average Times, Degradation
Level 1 Moving Average Number of Times, Degradation Level 2
Moving Average Number of Times, Trigger Type, Trigger Level,
Monitoring Delay Time, Monitoring Time
Trigger Mode, Moving Average Times, Trigger Type, Trigger
Level, Monitoring Delay Time, Monitoring Time
2 Basic Settings
2
27