Recording Video; Figure 45: Event Status - Storage Screen - Eneo TVR-2008AM4.0 User Manual

User's Manual
The Type column displays the type of storage device.
The Disk Bad column displays the percentage of bad sectors. Not formatted indicates the device is not formatted.
The Temperature column displays the temperature of the storage device.
The S.M.A.R.T. column displays "Good", "Bad" or "N/A", depending on storage conditions.
 Good – The storage condition is normal.
 Bad – Data cannot be written on or read from the storage device.
 N/A – Storage conditions are normal, however, the S.M.A.R.T. monitoring is not working or supported.
NOTE: When the storage condition is "Bad", the Event Status – Storage screen displays and you can check
the storage condition for details. Once the "Bad" message displays, replacing the hard disk drive is
recommended, usually within 24 hours.
Temperature and S.M.A.R.T. information will be available only for internal hard disk drives supporting
the SMART (Self-Monitoring Analysis and Reporting Technology) monitoring program.

Recording Video

Once you have installed the DVR following the instructions in Chapter 2 — Installation, it is ready to record. The DVR
will start recording based on the settings you made in the Record setup screen. See Chapter3 — Configuration.
Recycle On or Recycle Off. The factory default is Recycle On. It does this by recording over the oldest video once
the hard disk is full. Setting the DVR to Recycle Off causes it to stop recording once the hard disk is full.
Although you will be able to record without changing the unit from its original factory settings, you will want to take
advantages of the DVR's many tools. See Chapter 3 — Configuration for detailed descriptions of the recording mode
options.
64
Figure 45: Event Status – Storage screen.