Table of Contents
Advertisement
Other external flash units
Third-party flash units can be mounted on the hot shoe or connected via a sync cable. Be sure to
replace the cap on the external flash connector when it is not in use.
Note the following when using a third-party flash unit mounted on the camera hot shoe:
Using obsolete flash units that apply currents of more than about 250 V to the X-contact will
damage the camera.
Connecting flash units with signal contacts that do not conform to our specifications may damage
the camera.
M
Select mode
, choose a shutter speed no faster than the flash sync speed, and set [
setting other than [Auto].
Flash control can only be performed by manually setting the flash to the ISO sensitivity and
aperture values selected with the camera. Flash brightness can be adjusted by adjusting either
ISO sensitivity or aperture.
Use a flash with an angle of illumination suited to the lens. Angle of illumination is usually expressed
using 35-mm format equivalent focal lengths.
485
ISO] to a
K
Optional Accessories
Advertisement
Table of Contents
Need help?
Do you have a question about the OM-1 Mark II and is the answer not in the manual?
Questions and answers
Pressing the 'U' button is not changing the view it stays on the super control panel