OM SYSTEM OM-1 Mark II Instruction Manual page 483

3.
Adjust flash settings.
Highlight items using the
A Mode
P
Small
3
TTL
A
1
Off
B
Off
C
2
Group
Flash control mode
Flash
compensation
Optical signal
strength
Flash mode/output
Channel
4.
Set the unit mounted on the camera to [TTL AUTO].
Flash control settings for the FL-LM3 can only be adjusted using the camera.
FGHI
250 5.6 200
ISO
1/
F
Auto
- 0.0
+
0 ±
WB Auto
0.0 0.0
± ±
Low Ch1
1:02:03
[
1023
Choose a group. Changes to settings apply to all units in the selected
group. The unit mounted on the camera works as a member of Group
A.
Choose a flash mode.
Adjust flash output. When [Manual] is selected for flash mode, you
can choose a value for manual flash output.
Choose the brightness of the optical control signals emitted by the
flash units. Choose [High] if you have placed flash units close to
the maximum distance from the camera. This setting applies to all
groups.
Choose (standard) or FP (super FP). Choose super FP for shutter
A
speeds faster than the flash sync speed. This setting applies to all
groups.
Choose the channel used for flash control. Change the channel if you
find that other light sources in the area are interfering with remote
flash control.
buttons and rotate the front dial to choose settings.
Group, flash control mode
1
RC RC
Flash compensation
2
Optical signal strength
3
Channel
4
3
Flash mode
5
4
]
5
483
Optional Accessories