High-speed
SH2
Sequential
B
SH2
ProCap
ProCap SH1
Pro Capture
ProCap SH2
Self-timer 12
12s /
12s
Y
r
sec
12s
q
2s /
2s
Self-timer 2
Y
r
sec
2s
q
C /
C
Custom Self-
Y
r
timer
C
q
You can choose the frame advance rate and the maximum number of shots in each series (P.193).
B
Items marked with
B
of the shutter reduced. Use this option when even slight camera motion can cause blur, for example
during macro or telephoto photography. This is configured when [Anti-Shock
[Anti-Shock
Settings]
H
Items marked with
B
seconds, or in settings where the sound of the shutter would be unwelcome.
SH2 and ProCap SH2 can only be used with specific lenses. Visit our website for details.
B
B
To cancel the activated self-timer, press
B
In
,
,
F
B
g
B
shooting. In
SH1,
B
immediately preceding the current frame.
The camera takes photos at up to about 50 fps while the
shutter button is held all the way down. If [C-AF], [C-AF
[C-AF+TR], or [C-AF+TR
(P.100), the camera will focus before each shot.
When
will meter the brightness and determines the exposure before
each shot.
Capture starts when the shutter button is pressed halfway. The
camera starts recording pictures, including those captured while
the button was pressed halfway, when the button is pressed
all the way down (P.200). Focus and exposure during each
ProCap mode are the same as [
(
High-speed Sequential SH1) and [
s
Sequential SH2).
The shutter is released 12 seconds after the shutter button is
pressed all the way down. The self-timer lamp will light for about
10 seconds and then start to flash about 2 seconds before the
shutter is released. The camera focuses when the shutter button
is pressed halfway.
When the shutter button is pressed all the way down, the self-
timer lamp will start to flash and a photo will be taken after
about 2 seconds. The camera focuses when the shutter button is
pressed halfway.
Adjust self-timer settings, including the self-timer delay and the
number of shots taken when the timer expires (P.195).
allow you to take pictures with the small amount of blur caused by operation
t
(P.197).
use the electronic shutter. Use these with shutter speeds faster than 1/8000
s
G
and ProCap modes, the camera displays the view through the lens during
SH2, ProCap SH1, and ProCap SH2 modes, it displays the shot
B
J
[Metering during
g
.
191
Performing the sequential/self-timer shooting
] is selected for
[
AF Mode]
K
] (P.164)
is set to [Yes], the camera
] (
Sequential), [
B
s
SH2] (
B
s
] is set to [On] in
H
],
J
SH1]
B
High-speed
Need help?
Do you have a question about the OM-1 Mark II and is the answer not in the manual?
Questions and answers
Pressing the 'U' button is not changing the view it stays on the super control panel