Setting The Detailed Option Of Image Stabilizer - OM SYSTEM OM-1 Mark II Instruction Manual

M-IS1 (All Direction Shake I.S.)
M-IS2 (All Direction Shake I.S.)

Setting the detailed option of image stabilizer

When using lenses other than Micro Four Thirds or Four Thirds system lenses, input the focal length of
the lens.
1.
Press the INFO button while configuring [
Stabilizer] or [
using
FGHI
Focal Length
Image stabilization may be unable to compensate for excessive camera motion or very slow
C
shutter speeds. Use a tripod in these cases.
You may notice noise or vibration while image stabilization is in effect.
C
The setting selected with the lens image stabilization switch, if any, takes priority over that
C
selected with the camera.
This can be changed.
[S-IS Auto] functions as [S-IS1] when [On] is selected for
C
When you select [S-IS Auto] or [S-IS1] with
C
mode (P.190), the image stabilization will be suitable for camera moves in the depth
direction, compared to when used with other sequential shooting modes.
You can choose whether image stabilization will be performed while the shutter button is
B
pressed halfway.
Electronic image stabilization combined with VCM-controlled
image sensor movement.
VCM-controlled image sensor movement only.
Electronic image stabilization is not performed.
Image Stabilizer]. Input the focal length
n
and then press the OK button.
Set the lens focal length. Input the number that is printed on the lens.
[0.1] – [1000.0] mm
"Stabilization for IS Lenses (Lens I.S. Priority)" (P.210)
g
"Half-press image stabilization (
g
Image
K
[Lens I.S. Priority]
SH2/ProCap SH2 selected as the drive
B
Image Stabilizer)" (P.207)
6
Reducing camera shake (
205
K
Image Stabilizer
Focal Length
0 0 0 9 . 0 mm
MENU OK
(P.210).
Image Stabilizer /
K
Image Stabilizer)
n