Creating Pro 16Fx Floppy Disk Installation Diskettes - Xerox WorkCentre Pro 16FX User Manual

Creating Pro 16fx Floppy Disk Installation Diskettes

If floppy diskettes are required to install the WorkCentre Pro Series Printer Driver Software, the
user can order floppy diskettes or create a set of diskettes from CD-ROM.
To create a set of WorkCentre Pro Series Printer Driver floppy Diskettes, find a PC that has a
floppy diskette drive with a CD-ROM drive and follow the procedure below. Four or five blank high
density diskettes will be required.
Windows 3.1x:
1. Insert the WorkCentre Pro Series CD-ROM into the CD-ROM Drive.
2. Choose File from the menu bar in Program Manager, and then choose the Run...
command.
3. Type D:\MAKEDISK\MAKEDISK.EXE (or the appropriate drive letter depending on your
CD-ROM Drive) in the command line box. Click on the OK button to proceed.
4. Follow the on-screen instructions.
Windows 95/98 and Windows NT 4.0:
1. Insert the WorkCentre Pro Series CD into the CD-ROM Drive.
2. Click on the Start button and then choose the Run menu option.
3. Type D:\MAKEDISK\MAKEDISK.EXE (or the appropriate drive letter depending on your
CD-ROM Drive) in the command line box. Click on the OK button to proceed.
4. Follow the on-screen instructions.
To use the Floppy Disk Installation Disks created, follow the same procedure for your operating
system but refer to the floppy disk drive (A: B:) rather than the CD-ROM drive (D:).
118 Printer Driver