Xerox WorkCentre Pro 16FX User Manual page 18

Installation
(continued)
6 Installation
13. Remove the starter toner cartridge from the silver bag.
Vigorously shake the cartridge to loosen the toner.
Thoroughly shaking the cartridge will assure
maximum copies per cartridge.
Xerox has included a Starter Toner Cartridge.
Purchased replacement toner cartridges will yield
approximately three times the number of copies.
14. Remove the toner cartridge cover.
15. Slide the toner cartridge into the Pro 16fx until it locks
into place.
16. Close the front cover and the side cover.
Skip to the Printer Driver Software Installation section
in this User Guide to set up the Pro 16fx for printing.
17. Plug the power cord into the Pro 16fx and then into a
grounded outlet.
18. Turn on the power switch. In approximately two
seconds the ready indicator will light. Copying is now
possible.
Note: Save the carton and packing materials. They should
be used to repack the Pro 16fx if it has to be shipped for
servicing or moved.
19. Plug one end of the telephone line into the jack marked
"LINE". Plug the other end into a standard (RJ11c)
single-line telephone wall jack. Be sure not to plug this
cord into the "TEL" jack. The "TEL" jack is used to
attach an extension telephone or answering machine to
the unit.
Note: If your area experiences a high incidence of
lightning or power surges, we recommend that you install
surge protectors for the power and telephone lines.