Table of Contents
Advertisement
– E2 Clearing the Paper Path
Fuser Area
124
Problem Solving
(continued)
Warning: The fuser area is hot. Take care when
removing paper from the fuser area.
Note: Ensure that the alternate paper tray is lowered.
1. Press the release lever to open the side cover.
2. Pull down on the fuser lever.
This will release pressure on the paper.
If paper is not seen in this area skip to the Exit Area.
Caution: Do not pull paper up through the fusing unit.
Unfused toner may adhere in the area, resulting in
smudged copies.
3. Remove the sheet of paper, in the direction shown.
4. Push up on the fuser lever.
5. Close the side cover.
Advertisement
Chapters
Table of Contents
