Rear Panel Overview
1. Trig Out/Calibration
2. Reference Clock
1. Trig Out/Calibration
This connector can output various signals (press UTIL Aux Output to select
the desired output type.):
1) TrigOut: After this type is selected, the oscilloscope output a signal that can
reflect the current capture rate of the oscilloscope at each trigger.
2) Quick Edge: After this type is selected, the oscilloscope can output a quick
edge signal which can be used in the self-calibration of the oscilloscope.
3) GND: After this type is selected, the oscilloscope can output a ground level.
4) PassFail: After this type is selected, the oscilloscope will output a pulse
signal when failed waveforms are detected. Connect this signal to other
control systems to conveniently view the test results.
DS6000 Quick Guide
3.Video Output
5.USB DEVICE
4. LAN
Figure 12 Rear Panel Overview
7. AC Input/Switch
6.USB HOST
RIGOL
8. Lock Hole
9