Installation - Swann AMU-II Oxytrace Operator's Manual

AMU-II Oxytrace
Program List and Explanations

5 Installation

5.1 Sensors
5.1.1
5.1.1.1
5.1.1.2
5.1.2
5.1.2.1
5.2 Signal Outputs
5.2.1 and 5.2.2
5.2.1.1
5.2.1.2
A-96.150.541 / 111223
Miscellaneous
Flow: If a flow cell without flow measurement (e.g. B-Flow) is used,
choose none. With flow measurement select Q-Flow
O2 Offset: Manual, small correction of the offset.
Range -5 to 5 ppb
Quality Assurance: Switch the Quality Assurance on or off.
Level: Select quality level:
 Level 0: Off
Quality assurance procedure switched off. Any additional QA
menus are hidden.
 Level 1: Trend
 Level 2: Standard
 Level 3: Crucial
 Level 4: User
Edit user specific limits in menu 5.1.2.2
Note: The navigation in the menu <Signal Output 1> and <Signal
Output 2> is equal. For reason of simplicity only the menu
numbers of Signal Output 1 are used in the following.
Signal Output 1 and 2: Assign process value, the current loop
range and a function to each signal output.
Parameter: Assign one of the process values to the signal output.
Available values:
 Oxygen
 Temperature
 Sample Flow (if a flow sensor is selected)
 Saturation
Current Loop: Select the current range of the signal output.
Make sure the connected device works with the same current range.
Available ranges: 0–20 mA or 4–20 mA
57