Changing Parameters And Values - Swann AMU-II Oxytrace Operator's Manual

AMU-II Oxytrace
Operation
5.4.
Changing
parameters
Changing
values
30

Changing Parameters and Values

The following example shows how to change the logger interval:
Logger Sensors
Sensor type
Log interval
Disinf. Free chlorine
Clear logger
Temperature
Standards
Logger
Interval.
Log interval
5 min
Clear logger
10 min
30 min
1 Hour
Logger
Log interval
Clear logger
Logger
Log interval
Save ?
Clear logger
Yes
No
Alarm oxygen
Alarm High 10.00 ppm
Alarm Low 1.00 ppb
Hysteresis 0.10 ppb
Delay
Alarm oxygen
Alarm High 8.00 ppb
Alarm Low 1.00 ppb
Hysteresis 0.10 ppb
Delay
1 Select the parameter you want to
5.1.2 4.4.1
change.
FOME
30 min
2 Press [Enter]
no
NT5K
3 Press [
4.1.3
highlight the required parameter.
30min
4 Press [Enter] to confirm the selec-
no
tion or [Exit] to keep the previous pa-
rameter).
 The selected parameter is
4.1.3
highlighted (but not saved yet).
10 min
5 Press [Exit].
no
 Yes is highlighted.
4.1.3
6 Press [Enter] to save the new pa-
rameter.
no
 The system reboots, the new
parameter is set.
1 Select the value you want to
5.3.1.1.1
change.
2 Press [Enter].
3 Set required value with [
5 Sec
[
4 Press [Enter] to confirm the new val-
5.3.1.1.1
ue.
5 Press [Exit].
 Yes is highlighted.
5 Sec
6 Press [Enter] to save the new value.
] or [ ] key to
] key.
A-96.150.541 / 111223
] or