Table of Contents
Advertisement
AMU-II Oxytrace
Installation
3.9.3
Menu items
Terminating
resistor
Interface
Description
3.9.4
Menu items
Field Device
Description
24
RS485 Option
After the RS485 option has been installed, the <Installation>/
<Interface> menu item becomes visible. Select Modbus RTU or
Profibus as protocol.
On the last RS485 interface in the network, move the switch to the
position marked "Ron" to activate the terminating resistor.
The Modbus and Profibus interface descriptions can be downloaded
from www.swan.ch.
HART Option
The configuration is done via the following menu items:
<Installation>/<Signal Outputs>/<Signal Output 3>:
<Installation>/<Interface>/<Device Address>:
The HART® 7.x Field Device Specification can be downloaded from
www.swan.ch.
A Switch for terminating
resistor
A
A-96.150.541 / 111223
Advertisement
Table of Contents
