Quectel SG865W Series Hardware Design page 42

Vibration Drive Interface
Pin Name Pin No.
HAP_P 38
HAP_M 44
HAP_PWM_IN 50
VDD_HAP 27
HAP_BOOST_EN 33
Other Interfaces
Pin Name Pin No.
5G_PON_RST 270
USB_BOOT 478
CBL_PWR_N 467
PM_PWM1 251
PM_PWM2 248
RESERVED 12, 16, 122, 126, 132, 276, 282, 288, 294, 300, 305, 306, 311, 312, 318, 426
7, 8, 10, 13, 14, 18, 21, 22, 29, 30, 32, 37, 39, 40, 41, 42, 53, 54, 55, 56, 57, 65, 66, 76, 77, 79, 86,
90, 93, 94, 101, 102, 105, 106, 111, 113, 117, 127, 128, 130, 131, 134, 135, 136, 137, 138, 139,
140, 144, 148, 149, 153, 154, 155, 160, 161, 166, 167, 170, 171, 173, 178, 184, 191, 193, 201,
GND 202, 210, 212, 221, 223, 224, 225, 231, 235, 236, 238, 239, 246, 259, 262, 271, 279, 286, 296,
297, 301, 323, 327, 328, 332, 336, 337, 341, 357, 358, 367, 371, 397, 400, 401, 403, 410, 423,
430, 432, 433, 434, 441, 443, 448, 450, 451, 452, 453, 465, 480, 483, 484, 485, 487, 491, 492,
495, 496, 497, 501, 505–571
NOTE
1. Keep all RESERVED pins unconnected.
2. All GND pins should be connected to the ground network.
SG865W_Series_Hardware_Design
I/O Description
Haptics driver output
AO
(+)
Haptics driver output
AO
(-)
DI Haptics PWM input
Power supply for
PI
haptics
DO Haptics boost enable
I/O Description
PON control signal
DO
for 5G
Force the module
DI into emergency
download mode
Initiates power-on
DI
when grounded
DO PWM output 1
DO PWM output 2
DC Characteristics Comment
If unused, connect it to GND.
DC Characteristics Comment
Smart Module Series
41 / 117