Chapter 6 Options And Peripheral Equipment; Cables/Connector Sets - Mitsubishi Electric MELSERVO MR-J5 Series User Manual

6
OPTIONS AND PERIPHERAL EQUIPMENT
Precautions
• HIV wires are recommended to wire the servo amplifiers, options, and peripheral equipment. Therefore, the recommended
wire sizes may differ from those used for the previous generation servo amplifiers.
• To prevent an electric shock or a fire, correctly wire options and peripheral equipment, etc. in the correct combination.
6.1

Cables/connector sets

The IP rating indicated for cables and connectors is their protection against ingress of dust and water drops
when they are connected to a servo amplifier or servo motor. If the IP ratings of the cables, connectors, servo
amplifier, and servo motor differ, the overall IP rating is determined by the lowest IP rating of all the
components.
Purchase the cable and connector options indicated in this section for this servo amplifier.
Use the cables provided by Mitsubishi Electric and Mitsubishi Electric System & Service Co., Ltd. When fabricating a cable,
select a wire suitable for the application. For selection example, NFPA 79 (2018 Edition) in North America demands the use of
a listed, certified product that has a thermoset insulator and is compliant with the NEC standard RHH, RHW, RHW-2, XHH,
XHHW, or XHHW-2.
For information on options for servo motor power supplies, electromagnetic brakes, servo motor encoders, and load-side
encoders, refer to "WIRING OPTION" in the following manual.
Rotary Servo Motor User's Manual (For MR-J5)
For options for linear encoders, refer to "OPTION CABLES/CONNECTOR SETS" in the following manual.
MR-J5 Partner's Encoder User's Manual
Refer to "WIRING OPTION" in the following manual for options for direct drive motor power supplies and options for
encoders.
Direct Drive Motor User's Manual
6 OPTIONS AND PERIPHERAL EQUIPMENT
6.1 Cables/connector sets
6
253