Mitsubishi Electric MELSERVO MR-J5 Series User Manual page 129

*1 Although the diagram shows the input signal and the output signal each using a separate 24 V DC power supply for illustrative purposes,
the system can be configured to use a single 24 V DC power supply.
*2 The signal cannot be used in the velocity mode and torque mode.
*3 This diagram shows a sink I/O interface. For the source I/O interface, refer to the following.
Page 137 Source I/O interface
*4 Refer to "Parts identification" in the User's Manual (Introduction) for connecting an external encoder.
3 SIGNALS AND WIRING
127
3.6 Interface
3