Electrical Installation; Cable Cross-Sections And Cable End Sleeves - ProMinent DULCOMETER Installation And Configuration Manual

Measuring and control unit aegis s for cooling water applications
Table of Contents

Advertisement

IP 54 degree of protection

4.3 Electrical installation

4.3.1 Cable Cross-Sections and Cable End Sleeves

Without cable end sleeve 0.25 mm
Cable end sleeve without
insulation
Cable end sleeve with
insulation
10.
Screw the back part onto the control panel (using the PT
screws supplied).
11.
Reattach the ribbon cable.
12.
Position the front part in its parked position.
ð First electrically wire the controller and then complete the
control panel installation.
13.
Position the front part on the rear part of the housing and
screw the housing in place.
14.
Once again check that the seal is seated properly. Degree of
protection IP 54 can only be achieved if it is correctly fitted.
Put in place both hardware and software safety precautions to
ensure that the controller switches to a safe operating status in the
event of a fault. For instance, use limit switches, mechanical
locks, ...
Ensure that the controller is not energised during installation.
Make sure that the installation is only carried out by technically
trained personnel.
Observe the technical data in these instructions.
Minimum cross-section
2
0.20 mm
2
0.20 mm
2
Assembly and Installation
Maximum cross-section
1.5 mm
2
1.0 mm
2
1.0 mm
2
Stripped insulation length
8 - 9 mm
10 - 11 mm
15

Advertisement

Table of Contents
loading

Table of Contents